Drive Duet Transport Chair and Rollator

More Information

• Assembly instructions: Do not attempt to adjust or operate the Duet without carefully reading all instructions in this manual.
  - Remove all contents from carton: backrest, handle with tube, Rollator frame, wheels and pouch.
  - Open frame and slide padded backrest into frame brackets making sure snap buttons protrude through holes.
  - Unscrew tightening knob from handle and insert handle tube into frame at desired height lining up holes appropriately. Slide bolts through holes from the outside and tighten knob until secure.
  - Lay rollator on floor so seat is facing the floor and unfold the legs. Straighten the legs until the side hinges lock into place.
  - Attach pouch by securing snap buttons around frame.
• Safety Precautions:
  - Please make sure the Duet is fully opened, seat is down and the folding bar under seat is locked in the down position.
  - Be sure that both knobs are fully tightened and are at equal heights. Test Duet for stability before applying full weight to hand grips.
  - Test the loop locks before operating the Duet. When wheels are locked (see illustrations for locking and releasing locks below), lock bar on rear wheels should prevent wheels from turning. If the wheels turn while locked, please take unit back to dealer for adjustment. When locks are released, the wheels should turn freely.
  - Always lock loop locks before sitting and do not use seat when unit is on an incline or uneven ground.
  - Replace tires when significantly worn or damaged.
  - Before entering or leaving the chair, engage the dual wheel locks against the tire on both rear wheels. Make sure the front casters are in the forward position before transferring into or out of the chair.
  - Leaning forward while using the Duet as a transport chair with out proper assistance can cause tipping.
• Loop Lock Operation:
  Always engage and disengage wheel locks on both sides simultaneously.
  - When standing in a stationary position the user must pull up on the loop lock handle to hold the rear wheels in place.
  - To Temporarily Lock Wheels in Position - Press down on both loop locks with palms until you hear a CLICK that will tell you wheels are locked.
  - To Release Wheel Locks - Pull up on both loop locks with palms of hand to original position.
• Note: You and your attendant should consult a qualified professional for the correct techniques on ramp negotiations.

 WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

Specification

Warranty

Limited Lifetime warranty

Customer Reviews